BS15
Plumber in Kingswood, Bristol
Kingswood sits in South Gloucestershire on Bristol's east side, with Victorian Pennant stone terraces near the High Street and large areas of interwar and post war semis. A plumber here deals with hidden leaks under suspended floors, boilers losing pressure, ageing drains and hot water upgrades, all on Bristol Water supply and Wessex Water sewers.
Kingswood, BristolThe houses
Homes in Kingswood
Kingswood grew on the old coalfield east of Bristol and is now part of South Gloucestershire. The older streets have Victorian terraces in local Pennant stone. Around them are interwar and post war semis and bungalows, and later estates towards Hanham and Warmley. Many older homes have suspended timber ground floors with heating pipes underneath. Building control is South Gloucestershire Council, while water comes from Bristol Water and sewers belong to Wessex Water.
Boilers losing pressure
A sealed heating system that keeps dropping below 1 bar has water escaping somewhere. In Kingswood's older homes, pipes under suspended floors can leak for months without showing. Other causes are a weeping radiator valve, a failed expansion vessel or a pressure relief valve letting water out through the pipe outside. Our post on why a boiler is losing pressure goes through the checks.
Any repair inside the boiler must be done by a Gas Safe registered engineer. Check their ID on the Gas Safe Register.
Kingswood's older terraces often have the inside stop tap under the stairs or in the front room near the front wall, rather than under the kitchen sink. It is worth finding it now. An old stop tap that will not turn should be replaced before you need it in a hurry.
Testing for leaks on a meter
If you are on a meter, Bristol Water suggests a simple test: turn off all taps and appliances, read the meter at night and again in the morning. If it has moved, there is a leak. If the meter is outside, turn off the inside stop tap and repeat to see whether the leak is inside or on the supply pipe. Our water meter leak test guide explains each step.
South Glos specifics
Kingswood is South Gloucestershire, not Bristol City Council. That matters for building control, road gullies and planning, but not for water or sewers, which are the same companies as the rest of Bristol. Bristol Water says its water is moderately hard to very hard across its area, so limescale is as much a problem here as in the city.
Hanham, Warmley and Longwell Green sit next to Kingswood and share the same mix of older terraces and post war homes. The same jobs come up there: boilers losing pressure, leaks under floors and drains slowed by roots or old clay joints. Lead supply pipes are still possible in homes built before the 1970s, according to Bristol Water.
Most asked for in Kingswood
What people here ask for most
Boiler repair
No heating, no hot water, pressure loss or fault codes on combi, system and regular boilers.
Boiler repair in Kingswood
Leak detection
Damp patches, rising bills, low pressure or a Bristol Water leakage notice. We trace the leak and fix it.
Leak detection in Kingswood
Blocked drains
Sinks, toilets and outside drains cleared, plus CCTV checks. We tell you if the blockage is Wessex Water's to clear.
Blocked drains in KingswoodIs Kingswood covered by Bristol City Council?
No. Kingswood is in South Gloucestershire. Water is still from Bristol Water and sewers from Wessex Water.
Why does my boiler keep losing pressure?
Usually a small leak on the heating system, often under a floor, or a faulty expansion vessel or relief valve. It needs tracing.
Do you cover Hanham and Warmley too?
Yes, we cover Hanham, Warmley, Cadbury Heath and Longwell Green alongside Kingswood.
Kingswood
Need a plumber in Kingswood?
Send the details and get a reply to arrange a visit.