Plumber in Bradley Stoke

A Bradley Stoke house built in the early 1990s may be on its second boiler already, and the first replacements from the 2000s are now ageing too. When parts get hard to find or repairs keep coming back, it is time to look at a new boiler. Many owners switch from a regular boiler with a loft tank to a combi to free the airing cupboard, while larger family homes often keep a cylinder and move to a system boiler. Our post on replacing the original boiler in Bradley Stoke covers the choices, and the new boiler page explains each type.

All gas boiler work must be done by a Gas Safe registered engineer. Check their card on the Gas Safe Register.

Many Bradley Stoke homes also have a stop tap in the garage or under the stairs rather than under the kitchen sink. Find it before you need it.

Push fit plastic pipe is reliable when fitted well, but joints can weep after years of heating cycles, especially if a pipe was not fully inserted or is under strain. Common spots are the airing cupboard, behind the kitchen sink unit and under the bath. Lead is very unlikely in homes this new, but the hard water still matters. Bristol Water says its supply is moderately hard to very hard, so cylinder valves and combi heat exchangers scale up.

Newer estates usually have separate pipes for foul water and rainwater. A blocked foul drain shows up as slow toilets and gurgling. Drains serving only your home are yours to clear, while shared runs and public sewers are Wessex Water's. Some estate drains and roads were never adopted, so check your deeds if a shared pipe blocks.

Unvented cylinders in newer Bradley Stoke homes need a yearly service to keep most warranties valid. In England, work on them must be done by someone competent under Building Regulations G3. Hard water from Bristol Water furs up their safety valves, which is the usual reason for water dripping from the pipe below the cylinder.